OIL & GAS
Oilfield Truck Series
WELL DRILLING TRUCK
Key Features
- 8×8 configuration for oilfield terrains
- Driiling depth: 3,000-9,000m
- Mast clearance height: 40m
- Drawwork: Double drums with EATON WCB 324
- Power transmission system: hydraulic + mechanical
- Sludge tank capacity: 50-150cbm
COMPRESSED NITROGEN TRUCK
Key Features
- 8X4 configurantion for oilfield terrains
- Equipped with nitrogen compressor
- Increase well productivity
- Application for well stimulation
- For pressure maintenance and improving reservoir integrity
- Compress nitrogen as drilling fluids for safety of drilling operation
FRAC SAND TANKER TRUCK
Key Features
- 8X4 configurantion for oilfield terrains
- Transport fracturing proppant during oilfield fracturing operation
- Fully sealed and single-through compartment and three unloading ports at rear
- Material Q235
- GPS tracking system
CEMENTING TRUCK
Key Features
- 8X4 configurantion for oilfield terrains
- Transport and mix cement slurry cementing the casing and completion of oil and gas wells
- Triplex plunger pump
- Working pressure: 70Mpa
- Water discharge: 3,300L/min
- Agitaing capacity: 2,300L/min
PUMPING UNIT INSPECTION TRUCK
Key Features
- Equipped with an air source interface
and a hydraulic oil interface bucket - Pneumatic gear oiling machine and neumatic grease injector
- Pneumatic wax remover adding
machine and solvent tank - Hydraulic torque wrench to mount,
remove and re-tighten the large nuts
WELL FLUSH AND WAX REMOVAL
Key Features
- 8X4 configurantion for oilfield terrains
- Medium: crude oil, brine, water etc.
- Hot wash pressure: 35Mpa
- Pump discharge: 5,000L/hour
- Triplex plunger pump and horizontal layout boiler
- In-truck diesel generator
- Automatic control two stage heater
TRUCK MOUNTED WELL LOGGING UNIT
Key Features
- For wireline logging works in the oilfield
- Double drums: co-axial double drum
- Hydraulic transmission winch
- Lifting capabilities: 50kN (Φ11.8mm wireline), 25kN (Φ5.6mm wireline)
- Drum capacity: 6000m (φ11.8)/ 8000m (φ8.0)
- Lifting speed: 30-8000m/h
TRUCK MOUNTED STEAM BOILER
Key Features
- For oil well wax removal and surroundings cleaning
- Hot wash pressure: 8Mpa
- Pump discharge: 1,800L/hour
- Working temp ≤ 280℃
- Boiler output ≤ 700kW
- Water tank capacity: 5cbm
- Boiler fuel type: dieseal, LPG